(508) 656-7436
Get an EstimateCLINTON · WORCESTER COUNTY MA
We're based in Lancaster, just 5 miles up the road, so Clinton is home turf for us. We know the tight downtown lots, the hillside yards off Burditt Hill, and how the Building Department on Church Street runs a deck permit.
GET A FREE ESTIMATECLINTON MA 2026 — COMPOSITE DECK
$18,000 — $35,000
Pressure-treated decks start lower — typical 16x20 PT: $10,000–$18,000
What you pay depends on how much of the deck you actually build. Re-pouring footings and reframing is a different job than swapping the finish boards and railings on a sound frame. The ranges below are for a standard 16×20 (320 sq ft) deck in Clinton; tight-lot access and hillside footings can move the number.
| Scope of work | Pressure-Treated | Composite |
|---|---|---|
| New deck — footings, frame, decking, railings | $9,000–$12,500 | $16,500–$22,500 |
| Full teardown & rebuild (demo + new) | $10,000–$14,000 | $19,000–$26,000 |
| Resurface — new decking + railings (keep frame & footings) | $4,500–$6,500 | $12,000–$17,000 |
| New decking boards only (keep frame + railings) | $3,000–$5,000 | $9,000–$12,500 |
| Frame + footings only (structural, no decking) | $4,000–$6,000 | $4,000–$6,000 |
| Railings only | $1,000–$2,000 | $3,000–$5,000 |
Frame + footings pricing is the same for either finish because deck framing is pressure-treated lumber regardless of the decking you pick. Railings are usually quoted by linear foot of open perimeter. Figures are 2026 planning ranges for Clinton, MA — final price depends on lot access, deck height, footing count, and material grade.
FREE DECK COST ESTIMATOR
Pick the size, material, and how much of the deck you're building — from a full new build down to reframing footings only or just replacing the finish boards.
ESTIMATED COST RANGE
Planning estimate only, based on 2026 Central Massachusetts installed rates. Actual price depends on site access, deck height, ledge/soil, railings run, and material grade. A free on-site estimate gives you an exact number.
$10,000–$18,000
$18,000–$35,000
$14,000–$26,000
Building a deck in Clinton starts underground, and that's where a lot of cheaper builders cut corners. Worcester County sits in a frost zone that requires footings dug to 48 inches below grade — a full 4 feet — so the frost heave that comes with a Central Massachusetts winter can't lift and crack your structure. Clinton gets the freeze-thaw cycle hard: wet fall, deep January cold, mud season in March. We dig every footing to that 48-inch depth, set the piers on undisturbed soil below the frost line, and pour them right the first time. A deck that isn't footed to code will rack, pull away from the house, and fail an inspection you already paid for. We build it to last through decades of Clinton winters.
Clinton is not a wide-open suburb, and building here takes a builder who understands that. It's the most densely settled town in Worcester County by land area — a compact former mill town packed with two-family and three-family homes, tight side yards, and hills. Neighborhoods like Burditt Hill and Greeley Hill sit on real grade, and the older housing stock off High Street, Water Street, Chestnut Street, and Church Street was laid out generations ago on narrow, close-set lots. That means access is tight, property lines are close, and elevated second-floor decks off multi-family units are common. We've built enough decks on these streets to plan the framing, the stairs, and the material staging around a lot that a truck can barely fit down.
Because those lots are small, setbacks matter more in Clinton than in a spread-out town — a deck that would sit comfortably in the middle of a half-acre lot can crowd a side or rear property line here, so we check the zoning district's setback before we ever dig. Clinton also sits on the Wachusett Reservoir, and the Wachusett Dam and its watershed run right through town. Properties near the reservoir fall under the state Watershed Protection Act and DCR watershed rules, and work close to wetlands or the water's edge can trigger conservation review before a permit issues. We flag that early so a watershed or Conservation Commission question never blindsides your project mid-build.
Every deck in town is permitted through the Clinton Building Department at Town Hall, 242 Church Street, Room 11, under the Massachusetts state building code (780 CMR). A straightforward residential deck permit typically turns around in about one to two weeks once the application and site plan are in. From there the job runs through three inspections: a footing inspection before any concrete is poured, a framing inspection once the structure and ledger are up, and a final inspection when the rails, stairs, and decking are done. We handle the paperwork, pull the permit, and meet the inspector on site. And because our shop is only about 5 miles away in Lancaster, we're in Clinton constantly — if something needs a second look, we're not driving in from an hour out. We're right next door.
We recently built a 16x20 composite deck for a homeowner on the Burditt Hill side of Clinton, on a sloped lot with a tight side yard typical of the neighborhood. The grade dropped off fast behind the house, so the deck sat elevated on the downhill corner — we set eight footings to the full 48-inch frost depth on the low side to keep everything dead level and solid. Material was gray composite decking with black aluminum rails, low-maintenance for a busy family. Access was the real challenge: a narrow driveway meant hand-carrying most of the framing to the back. Footing, framing, and final inspections all passed clean with the Building Department, and we wrapped in about two and a half weeks.
Tight-lot & small-yard decks
Elevated & second-story decks
Two- & three-family decks
Hillside footings on grade
Cable & aluminum railings
Stairs & landing pads
Pergola & shade structure
Composite decking (Trex, TimberTech)
How much does a deck cost in Clinton MA?
A standard 16x20 composite deck in Clinton typically runs $18,000–$35,000, while the same size in pressure-treated wood runs about $10,000–$18,000. Clinton's tight downtown lots and hillside yards can add cost for material hand-carrying, harder access, or extra footings on elevated and multi-family decks.
Do I need a permit to build a deck in Clinton?
Yes. Every deck is permitted through the Clinton Building Department at Town Hall, 242 Church Street, Room 11, under the Massachusetts state building code (780 CMR). You'll need a completed application and a site plan showing the deck's size and setbacks. We pull the permit and handle the paperwork for you as part of the job.
How long does a deck project take in Clinton?
Permitting through the Church Street office usually takes about one to two weeks. Once we start building, a standard deck runs roughly two to three weeks depending on size, height, and access. Tight-lot and elevated Clinton jobs can take a little longer because of staging and hand-carrying material to the back of the house.
Is Maverick City Builders local to Clinton?
Very. We're based in Lancaster, only about 5 miles from Clinton, so it's one of the towns we work in most. We know the Burditt Hill and Greeley Hill grades, the tight lots off High and Water Streets, and how the Building Department runs. Being right next door means fast site visits and quick follow-up.
Composite or pressure-treated — which is better for a Clinton deck?
Pressure-treated costs less up front and suits a tighter budget. Composite costs more but resists rot, holds up on the shaded, damp lots common in Clinton's dense neighborhoods, and needs almost no upkeep — no annual staining. On two- and three-family homes where an elevated deck is hard to reach for maintenance, composite usually pays off over time.
My Clinton property is near the Wachusett Reservoir — does that affect my deck?
It can. Clinton sits on the Wachusett Reservoir and Dam, and properties near the water or wetlands fall under the state Watershed Protection Act and DCR watershed rules. Work close to the water's edge may need Conservation Commission review before a permit issues. We check this early so watershed rules never stall your project.
Maverick City Builders · Lancaster, MA · 5 miles from Clinton
Licensed HIC & CSL · Fully insured · All permits handled
GET AN ESTIMATE